Table of Contents
Advertisement
Quick Links
T
ECHNICAL
Related Standards
The Hub TR has been designed to conform to the following standards:
Functional
Safety
EMC
Physical
Width
Depth
Height
Weight
Mounting
SuperStack II Hub TR
12/24 Port
(3C510510B & 3C510511B)
User Guide
I
NFORMATION
IEEE 802.5
UL 1950, EN 60950:92, CSA 22.2 #950
FCC 20780, Part 15J, Class A
VFG243 Level A (with shielded cable)
EN55022 Level A
CSA 108.8, CE
17.3 in.
12 in.
2 5/8 in.
9 3/4 lbs.
free standing,
or 19" rack or wall mounted using kit
supplied
Electrical
Hub TR
Power Inlet
Fuse Protection
Power Consumption
Power Supply
Heat Dissipation
Environmental
Operating Temperature
Humidity
Storage Temperature
Storage Humidity
IEC 320
4 Amps
55 W
100 to 240 VAC, 47 to 63 Hz
187 BTU/hr
5-50˚C (32-122˚F)
up to 90% (non-condensing)
0 to 50 C
10% to 90% non-condensing
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for 3Com 3C510510B
Summary of Contents for 3Com 3C510510B
- Page 1 SuperStack II Hub TR 12/24 Port (3C510510B & 3C510511B) User Guide ECHNICAL NFORMATION Related Standards Electrical The Hub TR has been designed to conform to the following standards: Hub TR Functional IEEE 802.5 Power Inlet IEC 320 Safety UL 1950, EN 60950:92, CSA 22.2 #950...
-
Page 2: Network Connection
NTRODUCTION SuperStack II Hub TR hubs are intelligent stackable Token Ring hubs that Fault Resilience provide workstation connectivity for 802.5 Token Ring networks. SuperStack II Hub TR hubs offer sophisticated fault recovery and fault Available with either 12 or 24 ports, the Hub TR comes equipped with an prevention for Token Ring networks. -
Page 3: Front Panel
The SuperStack II Hub TR uses the following replacement fuse. 8260 hub with the Hub TR ONtrunk module. When connecting to Token Ring hubs other than 3Com, be sure to connect the cable first and then Fuse specification: 250 volts - 4A Slo-Blo switch Phantom to OFF. -
Page 4: Roving Rmon
Internetworking Port SuperStack II Hub TR hubs can be stacked in any combination with earlier LinkBuilder FMS TR hubs (#3C510500 and #3C510501). Refer to The Internetworking Port is a shielded RJ45 port that allows figure below for proper cascade cable installation switch/bridge connection to the ring. -
Page 5: Stacking Units
Air flow around the unit and through the vents in the side of the case is not restricted (3Com recommend that you provide a For free standing stacks The module can be fitted to an Hub TR at minimum of 25mm (1 inch) clearance). -
Page 6: Bulletin Boards
ULLETIN OARDS Products Bulletin Boards SuperStack II Hub TR is part of the SuperStack II range of 3Com products. Management agent software upgrades are available from these 3Com Contact your supplier for the latest product information. bulletin boards: Hub TR hubs... -
Page 7: Rack Mounting
OUNTING NSTRUCTIONS Introduction To wall mount the Hub TR unit(s): Ensure that the wall you are going to use is smooth, flat, dry and sturdy. The Hub TR is supplied with two mounting brackets and four screws. Attach a piece of plywood (12" x 20" x 0.5") securely to the wall if These are used for rack mounting and wall mounting the unit. -
Page 8: Warranty
NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, If a product does not operate as warranted during the applicable warranty period, 3Com MAINTENANCE OR USE OF ITS PRODUCTS.
Need help?
Do you have a question about the 3C510510B and is the answer not in the manual?
Questions and answers