3Com 3C780 - LinkBuilder FDDI Base Unit User Manual page 88

Chapter 4
Setting Up the Hub
The LinkBuilder FDDI Workgroup Hub is shipped ready to plug in and use
without the need to change any parameters. In all probability, however, you
will want to make a number of changes to adapt the hub to your network
environment. This chapter discusses how to use the management console
commands to set up the hub and make any desired parameter changes. Topics
include:
Commands
The commands supported by the management console command mode and the
primitive console command mode enable you to set and display the basic
parameters needed to configure and operate the hub. The commands are
grouped into three functional categories that are defined below:
Using commands to:
– Set addresses
– Set the password
– Set attachment port configuration
– Set station management parameters
Downloading new images
Use set commands to institute various functions.
Use show commands to display default parameter settings and reflect any
changes you make.
Use miscellaneous commands to support various diagnostic and
troubleshooting functions.
Setting Up the Hub
4-1