Show Ports - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

C-12 Commands

show ports

Syntax
show ports #
Description
The show ports command displays information about the ports on the media port
module specified by the slot number. After entering show ports, specify the slot
number of the module. If you do not specify a slot number, you will be
prompted for one.
The information provided is listed below:
Number of modules installed on the hub
Number of ports on the module
Port media type (fddiPORTPMDClass)
– Fiber = 62.5 µm multimode fiber
– STP = shielded twisted pair
– UTP = unshielded twisted pair
– LCF = low-cost fiber
– N/S = not specified
– Unknown = unknown connecting medium
– Sonet = synchronous optical network
Port PHY type (fddiPORTMy_Type)
– A = PHY A
– B = PHY B
– M = PHY M
– S = PHY S
– U = PHY unknown
Port neighbor type (fddiPORTNeighborType)
– A = PHY A
– B = PHY B
– M = PHY M
– S = PHY S
– U = PHY unknown