Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 6.0
System Manager's Guide 555-660-118
E
Removing/Reinstalling the Control Unit Cover
Removing the Control Unit Housing
Removing the Control Unit Housing
To remove the control unit housing, see
MERLIN LEGEND 2.1 and later
Figure E–1.
Installing the Control Unit Housing
Installing the control unit housing involves two tasks: installing the top cover and
then installing the front cover.
This section contains instructions for both tasks.
Installing the Top Cover
To install the control unit top cover, see
1.
Be sure the cords have been pressed through the wire managers at the
base of the modules.
2.
Hold the top cover with the hooks facing you.
3.
Engage the tabs at the rear of the top cover with the carrier.
4.
Lower the top cover so that the legs lock into the vents on the module.
MERLIN II and
Communications System
1
MERLIN LEGEND 2.0
and earlier
Communications System
Housing
1
Clip
Removing the Control Unit Housing
5
Figure
E–1.
2
2
Housing
5
5
Figure E–2
and follow these steps:
Issue 1
February 1998
Page E-2
Advertisement
Table of Contents
