Lucent Technologies MERLIN LEGEND 6 System Manager's Manual page 267

MERLIN LEGEND Communications System Release 6.0
System Manager's Guide 555-660-118
6 Managing the System
Using Reports
Printing System Programming Reports
System programming reports can be printed out or viewed on the screen of a PC
with SPM or printed out on a serial printer connected to the SMDR jack on the
processor module in the control unit. You can print individual reports or use the
option to print the entire set of available reports, including all report sections
and options. See Appendix F of System Programming for samples of the print
reports.
For more information, see "Print Reports" in Chapter 4, System Programming .
NOTES:
1. If you select the
2. If you select a report for which there is no information, the report
3. Print reports if you cannot back up your system programming
4. If your system must handle more than 100 calls per hour, do not print
5. If you are printing from the console, your printer must be connected to
To print system programming reports, use one of the following procedures:
Console Procedures
option, the reports take several minutes to print.
You may want to schedule use of the printer during off-peak hours.
header still prints.
information.
reports during regular hours.
the SMDR port. If you are programming on a PC with SPM, you have
the following choices:
Print reports on the SMDR printer (if available).
Print reports on the PC printer.
Save reports (on hard disk or floppy).
View reports (browse).
To print trunk information:
More
To print extension information:
More
no.
To print all other reports:
More
6
Select trunk type
More Dial ext.
Select report
Issue 1
February 1998
Page 6-37