Lucent Technologies MERLIN LEGEND 6 System Manager's Manual page 272

MERLIN LEGEND Communications System Release 6.0
System Manager's Guide 555-660-118
6 Managing the System
Adding an Extension
o
Make decisions about which features and buttons to assign to this
extension as described in the planning guidelines above. Record your
decisions on the appropriate planning forms.
o
Open the System Programming menu from the console or a PC with SPM.
o
If your system uses the Set Up Space numbering plan (see Form 2a),
single-renumber the extension jack following the instructions in "Single
Renumbering" in the "System Renumbering" section of System
Programming , Chapter 3.
o
If you are adding a personal line, Loudspeaker Paging, or Pool buttons
(Hybrid/PBX only), assign the outside lines/trunks to the buttons on the
telephone, following the instructions in "Assign Trunks or Pools to
Telephones" in the "Telephones" section of System Programming , Chapter
3.
Also, you may choose to copy line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and Night Service information (for
operator positions only) as described in "Copy Line/Trunk Assignments" in
the "Telephones" section of System Programming , Chapter 3.
o
Assign Intercom or System Access buttons by following the instructions in
"Assign Intercom or System Access Buttons" in the "Telephones" section of
System Programming , Chapter 3.
o
If the telephone is an analog multiline telephone and does not have a built-
in speakerphone (BIS) or Hands-Free Answer on Intercom (HFAI), identify
it as such to the system by following the instructions in "Analog Multiline
Telephone Without Built-in Speakerphone (BIS) or "Hands-Free Answer
Intercom (HFAI) Capability" in the "Telephones" section of System
Programming , Chapter 3.
o
If the telephone is an analog multiline telephone and requires a dedicated
pair of extension jacks to provide Voice Announce to Busy or to provide
voice and data features, identify it to the system as such by following the
NOTE:
This task requires Extension Forced Idle for this extension jack.
NOTE:
This task requires an idle condition: Extension Forced Idle.
NOTE:
This task requires an idle condition: Extension Forced Idle. Also, you
may choose to use the Copy Extension procedure described in
"Copying Feature and SA/ICOM Buttons" on page
Issue 1
February 1998
Page 6-42
6–29.