Quantum Trunk Properties - Altigen AltiContact Manager Version 5.0 Administration Manual

• Centrex Transfer - Applies to analog and T1 trunks if the trunk is
supported by Centrex. This option must be selected to forward calls to
an outside number through a Centrex switch. If the Centrex provider
requires a particular string to be sent before the dialed number, enter
the string in the Transfer Predial String box. If no string is set as a
predial string, FLASH is used.
• Attribute - In Service makes the trunk available for use. Out of
Service prevents the trunk from being used (for example, while
performing maintenance).
• Enable Tie Trunk - Allows hop-on and hop-off dialing for an ISDN/
PRI, or T1 trunk. When this box is checked, any incoming call to the
selected trunk can be sent with ANI/DNIS information. To use this
feature, Hop-off must also be enabled under System Configuration
Call Restrictions, as discussed in "Defining System Call Restrictions"
on page 5-16. Also, the board must be configured to allow for tie
trunks. See "Setting up T1, PRI or E1 Channels on the Triton T1/PRI
Board" on page 6-25.
• Holiday Profile - A holiday profile can be assigned to a trunk. The
drop- down list selection is based on settings configured in the
Holiday page of System Configuration (see "Routing Calls on
Holidays" on page 5-13)
• Business Hour Profile - A business hour profile can be assigned to a
trunk. The drop-down list selection is based on settings configured in
the Business Hours page of System Configuration.
• Trunk Properties - Opens a dialog box that allows you to configure
low-level, hardware-specific properties for each trunk. The options
vary depending on the type of board and trunk; this is discussed in
subsequent sections.
• Record Option - Recording for incoming and outgoing calls is
supported for Triton Analog, T1/E1, and IP trunks; use the drop-down
list to select Disable or Enable.

Quantum Trunk Properties

To configure a Quantum channel, select a Quantum channel from the trunk
channels list in the Trunk Configuration window, then click the Trunk
Properties button or double-click the list entry to view the Quantum
Trunk Line Properties dialog box.
AltiContact Manager Administration Manual
Trunk Configuration
7-5