Table of Contents
Advertisement
Software Installation
New Installation
Before New Installation
Note:
Triton T1 Rev A1/A2 or VoIP Rev A1/A2 boards are not supported
in AltiContact Manager. These boards must be replaced with Rev
A3 or later boards.
Before you begin, have the following at hand:
•
System Key
•
The 20-digit software license key (located on the End User License
Agreement)
•
The system home area code
•
The extension length
Note: The extension length, which is from 3–6 digits, is the number
of digits for all extension numbers. All extensions in the
AltiContact Manager configuration must be the same length.
You cannot change the extension length once the first
extension is configured, which is something you do later
running the AltiContact Manager Setup. To change the
extension after extensions are configured requires
reconfiguring the entire system or deleting all the extensions
and groups already configured.
•
Internet Explorer 5.0 or higher (for online registration)
To Begin New Installation
To install AltiContact Manager:
1.
Make sure you have prepared for installation as described beginning
on page 3-2.
2.
Install the System Key on the parallel or USB port.
Caution: Do not connect the system key to any AltiGen board as
damage may occur to the board or the system key.
AltiContact Manager Administration Manual
3-11
Advertisement
Table of Contents
Troubleshooting
