Table of Contents
Advertisement
Setting General Trunk Attributes
Attribute
Trunk Properties
Quantum Trunk Properties
To configure a Quantum channel, select a Quantum channel from the trunk
channels list in the Trunk Configuration window, then click the Trunk
Properties button or double-click the list entry to view the Quantum
Trunk Line Properties dialog box.
Figure 3. Quantum Trunk Line Properties window
Note that you can use Apply to... on this dialog box to apply changes to
other trunks of the same type. See "Configuring One or Multiple Trunks"
on page 173.
176 AltiWare OE System Installation & Administration Manual
Description
Opens a dialog box that allows you to configure low-
level, hardware-specific properties for each trunk.
The options vary depending on the type of board and
trunk; this is discussed in subsequent sections.
Advertisement
Table of Contents
Troubleshooting
