Proper Board Handling Procedures; Electrostatic Discharge (Esd) Warning; Operating Environment - Altigen AltiContact Manager Version 5.0 Administration Manual

Cuando en un mismo sistema se encuentren instaladas más de dos tarjetas de telefonía
AltiGen, también se requerirá de la instalación de un ventilador adicional de enfriamiento. Es
menester que este abanico reduzca efectivamente el calor e incremente el flujo de aire que
ingresa a las tarjetas de telefonía AltiGen, a fin de garantizar la fiabilidad y la seguridad
funcional del sistema. Para instalar el ventilador de enfriamiento en el sistema , lea las
instrucciones que se incluyen con la unidad de ventilación.
Befinden sich mehr als zwei AltiGen Fernmeldekarten in der AltiWare Anlage, muß ein
zusätzlicher Ventilator eingebaut werden. Dieser Ventilator hat die Aufgabe, effektiv Hitze zu
reduzieren und gleichzeitig den Luftstrom zu den Fernmeldekarten zu erhöhen, um die
Zuverlässigkeit der Anlage zu gewährleisten. Beim Einbau eines Ventilators in die Anlage
sind die dem Ventilator beigefügten Anleitungen zu beachten.

Proper Board Handling Procedures

Handle boards by the edges only. Always hold the boards individually by
the face plate (with the components facing you) and pinching the edge on
the right side of the board. Do not make contact with the solder or
component sides of the boards. Do not slide the boards over any surface,
including an electrostatic discharge mat. Some boards have very sensitive
ceramics that contain embedded traces. These traces are very close to the
edge of the component and are easily chipped if they are hit against a hard
object or surface.

Electrostatic Discharge (ESD) Warning

Electrostatic discharge is caused by static electricity. It can damage boards
and may result in hard failures, early life failures, or cause a system to
experience intermittent, erratic behavior. Always use an ESD kit when
working on the telephony boards. The use of a special wrist strap or foot
strap (to ground the wearer to the computer's case) reduces the risk of ESD
damage.

Operating Environment

(Condiciones Ambientales de Operación/Betriebsbedingungen)
Before you set up and use the system, consider the environment in which
the system will reside:
• Choose a work surface large enough to accommodate the entire
system.
2-14 AltiContact Manager Administration Manual