Setting General Trunk Attributes
• Trunk Properties - Opens a dialog box that allows you to configure
low-level, hardware-specific properties for each trunk. The options
vary depending on the type of board and trunk; this is discussed in
subsequent sections.
Quantum Trunk Properties
To configure a Quantum channel, select a Quantum channel from the trunk
channels list in the Trunk Configuration window, then click the Trunk
Properties button or double-click the list entry to view the Quantum
Trunk Line Properties dialog box.
Figure 3. Quantum Trunk Line Properties window
Note that you can use Apply to... on this dialog box to apply changes to
other trunks of the same type. See "Configuring One or Multiple Trunks"
on page 7-3.
7-6 AltiWare OE System Installation & Administration Manual