Understanding The Setup Wizard; About Dual-Wan Port Appliances - Symantec 360R - Security Gateway SGS Administration Manual

Understanding the Setup Wizard

About dual-WAN port appliances

The Setup Wizard launches when you first browse to the appliance. The Setup
Wizard helps you configure basic connectivity to the Internet or your intranet.
If you have already successfully run the Setup Wizard and verified WAN
connectivity to the outside network, you do not need to do any additional setup
for WAN 1. For models 360 or 360R, use the SGMI to configure WAN 2. See the
Symantec Gateway Security 300 Series Installation Guide for more information
about using the Setup Wizard.
Note: To change the language in which the SGMI appears, rerun the Setup
Wizard and select a different language.
The Setup Wizard verifies the current status of the WAN 1 connection before
proceeding. If the WAN port (called WAN 1 on models 360 and 360R) is
connected to an active network, the Setup Wizard guides you through
configuring LiveUpdate and the administration password. If the WAN port is
not currently active, the Setup Wizard guides you through entering your ISP-
specific connection parameters. Use the WAN/ISP tabs to configure advanced
connection settings or to configure WAN 2 port.
You can re-run the Setup Wizard at any time after the initial installation. To run
the Setup Wizard, on the WAN/ISP > Main Setup window, click Run Setup
Wizard. See the Symantec Gateway Security 300 Series Installation Guide for
more information.
Warning: Anything you type and save on the WAN/ISP tabs overwrites what you
entered previously in the Setup Wizard. This may cause loss of WAN
connectivity.
Symantec Gateway Security 300 Series models 360 and 360R appliances have
two WAN ports, WAN 1 and WAN 2. The model 360 and 360R appliances
support different types of network settings on each of its WAN ports. For
example, you may have a static IP account through your business as the primary
WAN connection and a secondary (and less expensive) dynamic IP account for a
backup connection. Each WAN port is treated as a completely different
connection.
Some configurations apply to both WAN ports and for other configurations you
must configure each WAN port separately.
Configuring a connection to the outside network
Understanding the Setup Wizard
Table 3-1 indicates the configuration
27