18 Administering the security gateway
Managing administrative access
Figure 2-2
shows a remote management configuration.
Figure 2-2
Remote management
To configure remote management, specify both a start and end IP address. If you
only want to remotely manage from only one IP address, type it as both the start
and end IP address. The start IP address would be the lower number in the range
of IP addresses and the end IP address would be the higher number in the range
of IP addresses. Leave these fields blank to deny remote access to the SGMI.
To configure for remote management
See
"Basic Management tab field descriptions"
1
In the SGMI, in the left pane, click Administration.
2
In the right pane, on the Basic Management tab, under Remote
Management, in the Start IP Address text boxes, type the first IP Address
(lowest in the range).
SGMI
Internet
Symantec Gateway Security
300 Series appliance
Protected devices
on page 158.