Configuring Remote Management - Symantec 360R - Security Gateway SGS Administration Manual

Configuring remote management

To manually reset the password
1
On the back of the appliance, press the reset button for 10 seconds.
2 Repeat the configure a password procedure. See
password" on page 17.
You can access the SGMI remotely from the WAN side using a computer with an
IP address that is within configured range of IP addresses. The range is defined
by a start and end IP address configured on the Remote Management section on
the Administration/Basic Management tab. You should configure the IP address
for remote management when you first connect to the SGMI. Remote
management is sent in MD5 hash.
Note: For security reasons, you should perform all external remote management
through a Gateway-to-Gateway or a Client-to-Gateway VPN tunnel. This
provides an appropriate level of confidentiality for your management session.
See "Establishing secure VPN connections"
Administering the security gateway
Managing administrative access
"To manually reset the
on page 81.
17