Routing Tab Field Descriptions - Symantec 360R - Security Gateway SGS Administration Manual

174 Field descriptions
WAN/ISP field descriptions

Routing tab field descriptions

Use the routing table to configure static or dynamic routing for your security
gateway.
Table C-16 Routing tab field descriptions
Section Field
Dynamic Routing Enable RIP v2
Static Routes Route Entry
Destination IP
Netmask
Gateway
Interface
Metric
Routing Table List Destination
Mask
Gateway
Interface
Metric
Description
Enables dynamic routing. Use this only for
intranet or department gateways.
Select an entry from the list to edit or delete.
IP address/subnet for traffic requiring routing.
Mask (used with the destination IP address) to
set range of IP addresses for traffic requiring
routing.
IP address of the router to which to send traffic,
that meets the IP address and mask combination
of destination IP address and netmask.
Appliance interface to which the defined traffic
is routed.
Options include:
Internal LAN
■
External WAN 1
■
External WAN 2
■
Integer representing the order in which you
want the routing statement executed. For
example, 1 is executed first.
IP address/subnet for traffic requiring routing.
Mask (used with the destination IP address) to
set range of IP addresses for traffic requiring
routing.
IP address of the router to which to send traffic,
that meets the IP address and mask combination
of destination IP address and netmask.
Appliance interface to which the defined traffic
is routed.
Integer representing the order in which you
want the routing statement executed. For
example, 1 is executed first.