Symantec 360R - Security Gateway SGS Administration Manual page 131

Figure 9-5 shows the rear panel of models 360 and 360R. This graphic is for
reference; the full description ofeach feature is available in the Symantec
Gateway Security 300 Series Installation Guide.
Figure 9-3 Model 360 and 360R rear panel
To flash the firmware
1 To turn off the power, press the power button on the back panel of the
appliance.
2 Turn DIP switches 1 and 2 (4) to the on (up) position.
3 To turn on the power, press the power button (7).
4 Copy the firmware file and the symcftpw utility into a temporary folder on
your hard drive.
5 Double-click the symcftpw icon.
6 In the Server IP text box, type the IP address of the appliance.
The default IP address of the appliance is 192.168.0.1.
7
In the Local File text box, type a file name for the firmware upgrade file.
8 Click Put.
Wait several minutes before restarting the appliance. Flashing is complete
when symcftpw reports that flashing is complete, LEDs 2 and 3 stop
flashing alternately, the appliance has restarted, and then LEDs 1 and 3 are
illuminated steadily. This may take several minutes.
9
Turn DIP switches 1 and 2 (4) to the off position (down).
Running LiveUpdate Now
Run LiveUpdate Now is the manual LiveUpdate feature. Run LiveUpdate Now
immediately checks for the latest firmware updates for your appliance and
installs it. If you are already running the latest version, it does not update your
appliance. LiveUpdate updates retain your configuration.
Logging, monitoring and updates
Updating firmware
131