Symantec 360R - Security Gateway SGS Administration Manual page 190

190 Field descriptions
VPN field descriptions
Table C-25 Dynamic Tunnels field descriptions
Section Field
Local Security PPPoE Session
Gateway
Local Endpoint
(Model 360/360R)
ID Type
Phase 1 ID
NetBIOS
Broadcast
Description
The default PPPoE session is Session 1.
This requires an ISP PPPoE account. If you have
a single-session PPPoE account, leave the PPPoE
session at Session 1.
Port on the security gateway where you want the
tunnel to end.
Options include:
WAN1
■
WAN2
■
ID type used for ISAKMP negotiation.
Options include:
IP Address
■
Distinguished Name
■
The default value is IP Address.
Value that corresponds to the ID Type. This
value is used to identify the security gateway
during phase 1 negotiations.
If you selected IP address, type an IP address. If
you selected Distinguished Name, type a fully
qualified domain name. If you select IP address
and leave this field blank, the default value is the
IP address of the security gateway's internal
interface.
The maximum value is 31 alphanumeric
characters.
Allows browsing of the VPN network in the
Network Neighborhood and file sharing on a
Microsoft Windows computer. A WINS host is
needed to accept the traffic.
NetBIOS broadcast is disabled by default.