Symantec 360R - Security Gateway SGS Administration Manual page 20

20 Administering the security gateway
Managing the security gateway using the serial console
6 In the terminal program, set the program to connect directly to the COM
port on your computer to which the appliance is physically connected.
7 Set the communication settings as follows:
Baud (Bits per second)
Data bits
Parity
Stop bits
Flow control
8 Connect to the appliance.
9 After the terminal has connected to the appliance, on the rear panel of the
appliance, quickly press the reset button.
10 At the prompt, do one of the following:
Local IP Address
Local Network Mask Type 2 to change the netmask of the appliance.
DHCP Server
9600
8
None
1
None
Type 1 to change the IP address of the appliance.
Type 3 to enable or disable the DHCP server feature of the
appliance.