Symantec 4420 Quick Start

4400 series

Table of Contents

Download this manual

Quick Start

S y m a n t e c C l i e n t l e s s V P N

G a t e w a y 4 4 0 0 S e r i e s

Installing and setting up the Symantec Clientless VPN Gateway 4400 Series appliance

The following instructions describe installing and setting up the appliance and one interface for management. Before

you begin the appliance installation and setup, you need to know its inside static IP and netmask addresses. For

instructions on how to configure the second interface, see the Symantec Clientless VPN Gateway 4400 Series

Installation Guide.

Mount the appliance in the appropriate rack or place it on a stable, level surface. Refer to these back panel

graphics for the location of various features in the instructions that follow.

Part Number: 10209303

Model 4420

Model 4460

Table of Contents

Do you have a question about the 4420 and is the answer not in the manual?

Page 1 The following instructions describe installing and setting up the appliance and one interface for management. Before you begin the appliance installation and setup, you need to know its inside static IP and netmask addresses. For instructions on how to configure the second interface, see the Symantec Clientless VPN Gateway 4400 Series Installation Guide.
Page 2 Note: To turn off the appliance, press the down [No] The configuration is not saved, the system arrow on the front panel until you see Symantec restarts, and all your information is lost. The CVG 5.0 Shutdown on the LCD. Press the e button default selection is [No].

4460