Resetting The Appliance - Symantec 360R - Security Gateway SGS Administration Manual

Resetting the appliance

The default IP address of the appliance is 192.168.0.1.
7 In the Local File text box, type a file name for the backup file.
8 Click Get.
9 Turn DIP switches 1 and 2 to the off (down) position.
You can reset the appliance in three different ways:
Basic reset
■
Restarts the appliance. This is similar to turning off and then turning on the
appliance. All current connections, including client VPN tunnels, are lost.
Previously connected Gateway-to-Gateway VPN tunnels are reestablished
when the appliance restarts. Also, the appliance performs a self-test of the
hardware when the appliance restarts.
Reset to the default configuration
■
The LAN subnet IP address is reset to 191.168.0.0, the LAN IP address of the
appliance is reset to 192.168.0.1, the DHCP server functionality is enabled,
and the administrator's password is reset to blank.
Reset to the reserved application
■
The firmware resets to the last all.bin firmware file that was used to flash
the appliance. This is either the factory firmware or a firmware upgrade
that you downloaded from the Symantec Web site and applied to the
appliance.
Note: LiveUpdate does not download and apply all.bin firmware upgrades.
To reset the appliance
There are three types of factory reset, which you can perform using a
combination of the DIP switches and the reset button. You must use a paper clip
or pen tip to press the reset button. Refer to
location of the reset button and DIP switches.
Figure 9-4 shows the rear panel on model 320. This graphic is for reference; the
full description of each feature is available in the Symantec Gateway Security
300 Series Installation Guide.
Logging, monitoring and updates
Backing up and restoring configurations
Figure 9-4 and Figure 9-5
135
for the