Symantec 360R - Security Gateway SGS Administration Manual page 153

Table C-1 Status tab field descriptions (Continued)
Section Field
LAN (External IP Address
Port)
Physical Address
Netmask
DHCP Server
Unit Firmware Version
Language Version Displays the factory version or the most recent
Model
Exposed Host
Special
Applications
NAT Mode
Logging/Monitoring field descriptions
Description
Displays the IP address of the security gateway.
The default value is 192.168.0.1.
Displays the physical address (MAC) of the
security gateway's LAN's port. The default value
is the factory setting.
Displays the network mask address as set on the
LAN tab. The default value is 255.255.255.0.
Displays enabled or disabled, depending on
whether the security gateway acts as a DHCP
server for connected clients.
Displays the factory firmware version or the
firmware version from the most recent
LiveUpdate or manual update.
update.
Displays the model number of the security
gateway.
Displays enabled if you have enabled a computer
on your network as an exposed host.
Displays enabled or disabled. If you have
configured any special applications, this field
displays enabled.
Displays enabled or disabled.
If you disable NAT mode, this disables the
firewall security functions and the security
gateway behaves as a standard router. Only use
this setting for intranet security gateway
deployments where, for example, the security
gateway will be used as a wireless bridge on a
protected network.
When NAT mode is enabled, the security
gateway behaves as a 802.1D network bridge
device.
Field descriptions 153