Configure - HP StorageWorks 2/16 - SAN Switch Manual

Fabric OS reference guide
See Also
configdefault
configshow
configupload

configure

configure
Changes system configuration settings.
Syntax
configure
Availability
Admin
Description
Use this command to change system configuration settings, including:
This command cannot be executed on an enabled system except for application attributes. The
application attributes can be configured when the system is enabled; to configure any other
settings, you must first disable the system, using the
The
top-level menu and its associated submenus consists of a text prompt, a list of acceptable
values (if appropriate), and a default value (shown in brackets). The default value is used with
the carriage return, which is a special input case (see
Switch Fabric Settings
There are a number of settings that control the overall behavior and operation of the fabric.
Some of these values, such as the domain, are normally assigned by the fabric and may differ
from one switch to another. However, other parameters, such as the buffer-to-buffer credit or
the time out values, can be changed to suit particular applications or operating environments,
but must be in agreement among all switches to allow formation of the fabric.
Table 13
following the table.
164
"Switch Fabric Settings" next
"Virtual Channel Settings" on page 167
"Zoning Operation Parameter" on page 168
"RSCN Transmission Mode" on page 169
"Arbitrated Loop Settings" on page 169
"System Services Settings" on page 170
"Portlog Events Disable and Enable
"Application Attributes" on page 172
command is navigated by entering a series of hierarchical menus. Each
configure
defines the settings affecting the fabric that can be changed. Each field is described
Settings" on page 171
switchdisable
"Special Inputs" on page 172).
Fabric OS 3.x Document Addendum
command.