HP StorageWorks 2/16 - SAN Switch Manual page 143

To delete a RADIUS server from the configuration:
1. Issue the following command:
2. At the prompt, enter y to complete the command.
When the command succeeds, an event is sent to the event log, indicating that the server is
removed.
To change the parameters of a RADIUS server that is already configured, issue the following
command:
To change the order in which RADIUS servers are contacted for service, issue the following
command:
When the command succeeds, it triggers an event log, indicating that a server configuration is
changed.
Enabling and Disabling Local Authentication:
Fabric OS 3.x Document Addendum
aaaConfig "--remove server | all"
where:
Is a server listed either by name or IP address. Enter either the
server
name or IP address of the server to be removed.
Is a keyword that removes all servers. If RADIUS service is
all
enabled, this removes all but the server in the first position. If
RADIUS service is disabled, all servers are removed.
aaaConfig "--change server [-p port] [-s secret] [-t timeout]
[-a pap | chap]"
where:
Is a server listed either by name or IP address. Enter either
server
the name or IP address of the server to be changed.
Is an option; enter a server port.
-p port
Is an option; enter a shared secret.
-s secret
Is an option; enter the length of time (in seconds) the server
-t timeout
has to respond before the next server is contacted.
-a pap | chap Is an option; specify that the PAP protocol be used instead of
the CHAP protocol for packets traveling between the switch
and the server.
aaaConfig "--move server to_position"
where:
Is a server listed either by name or IP address. Enter either the
server
name or IP address of the server whose position order is to be
changed.
to_position Is the number of the position to which the server is to be
moved.
Fabric OS procedures user guide
143