Welcome... Configure Your San Dialog Box - HP StorageWorks SN6000 - Fibre Channel Switch User Manual

13. If Simple SAN Connection Manager detects another unconfigured switch, the New Switch Setup
wizard opens again for that switch and guides you through its setup.
After you have either completed all the steps required in the New Switch Setup procedures
through step
dialog box
Figure 19

Welcome... Configure Your SAN dialog box

14. Select from the following SAN configuration options:
• To prevent the Welcome dialog box from opening every time you start Simple SAN Connection
Manager, clear the Always show this screen at the application startup check box. (Be aware that if
you clear this check box, you cannot later reinstate the Welcome dialog box.)
• To exit this dialog box without performing any configuration, and view the Simple SAN Connection
Manager main window, click Close. (All configuration options offered on this dialog box are also
available from the main window.)
• To launch the Create New Logical Disk wizard and add a new logical disk to your SAN, click
Create Logical Disk Wizard. For details, see either
page 86 or
• To open the Perform Other Operations dialog box
configuration options, click Perform Other Operations.
42 Getting started
9), or opted not to set up the switch at this time, the Welcome... Configure Your SAN
(Figure 19) appears.
"Creating a logical disk—MSA storage"
"Creating a logical disk—EVA storage"
on page 90.
(Figure 20) and select from additional
(step 4
on