HP StorageWorks 2/16 - SAN Switch Manual page 116

Diagnostic and system error messages reference guide
SEC-INITERR
Message
<timestamp>
ERROR SEC-INITERR, 2, Initialization failed: Switch is not security
capable. Disabling Security mode.
Probable Cause
The secmodeenable command failed because the switch does not support secure mode.
Recommended Action
Check that all conditions required for secure mode are installed on the switch. Correct any
missing requirements, such as a missing zoning license, RCS capability, or the PID mode on
the switch. Refer to the HP StorageWorks Secure Fabric OS Version 1.0 User Guide for more
information on secure mode requirements.
Severity
ERROR
SEC-PIDCHGERR, PID Change failed: Change Area failed
Message
<timestamp>
ERROR SEC-PIDCHGERR, 2, PID Change failed: Change Area failed. <defined
status> <active status>
Probable Cause
Either the defined or active policy could not be updated. If the policy database is very large, it
might not be able to change the area because the new policy database exceeds the maximum
size. This message can also be caused when the switch is short of memory. The status values
can be defined, active, or both. A negative value means that a policy set was failed by
the daemon.
Recommended Action
Reduce the size of the policy database.
Severity
ERROR
116 Fabric OS 3.x Document Addendum