Eem Example Configuration; Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

EEM Example Configuration

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
show event manager system-policy [all]
show running-config eem
show startup-config eem
EEM Example Configuration
This example overrides the __lcm_module_failure system policy by changing the threshold for just
module 3 hitless upgrade failures. This example also sends a syslog message. The settings in the system
policy, __lcm_module_failure, apply in all other cases.
event manager applet example2 override __lcm_module_failure
event module-failure type hitless-upgrade-failure module 3 count 2
action 1 syslog priority errors msg module 3 "upgrade is not a hitless upgrade!"
action 2 policy-default

Default Settings

Table 54-1
Table 54-1
Parameters
system policies
Cisco MDS 9000 Family CLI Configuration Guide
54-12
lists the default settings for EEM parameters.
Default EEM Parameters
Chapter 54 Configuring the Embedded Event Manager
Purpose
Displays information about the predefined system
policies.
Displays information about the running
configuration for EEM.
Displays information about the startup
configuration for EEM.
Default
active
OL-18084-01, Cisco MDS NX-OS Release 4.x