C H A P T E R 55 Configuring Fabric Configuration Servers; Fcs Name Specification - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 55 Configuring Fabric Configuration Servers
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

FCS Name Specification

You can specify if the unique name verification is for the entire fabric (globally) or only for locally
(default) registered platforms.
Set this command globally only if all switches in the fabric belong to the Cisco MDS 9000 Family.
Note
To enable global checking of the platform name, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fcs plat-check-global vsan 1
switch(config)# no fcs plat-check-global vsan 1
To register platform attributes, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fcs register
switch(config-fcs-register)#
Step 3
switch(config-fcs-register)# platform name
SamplePlatform vsan 1
switch(config-fcs-register-attrib)#
switch(config-fcs-register)# no platform name
SamplePlatform vsan 1
switch(config-fcs-register)#
Step 4
switch(config-fcs-register-attrib)# mgmt-addr
1.1.1.1
switch(config-fcs-register-attrib)# no
mgmt-addr 1.1.1.1
switch(config-fcs-register-attrib)# mgmt-addr
2001:0DB8:800:200C::417A
switch(config-fcs-register-attrib)# no
mgmt-addr 2001:0DB8:800:200C::417A
Step 5
switch(config-fcs-register-attrib)# nwwn
11:22:33:44:55:66:77:88
switch(config-fcs-register-attrib)# no nwwn
11:22:33:44:55:66:77:88
Step 6
switch(config-fcs-register-attrib)# type 5
switch(config-fcs-register-attrib)# no type 5
Step 7
switch(config-fcs-register-attrib)# exit
Step 8
switch(config-fcs-register)# exit
switch(config)#
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Enables global checking of the platform
name.
Disables (default) global checking of the
platform name.
Purpose
Enters configuration mode.
Enters the FCS registration submode.
Enters the FCS registration attributes submode.
Deletes a registered platform.
Configures the platform management IPv4
address.
Deletes the platform management IPv4
address.
Configures the platform management IPv6
address.
Deletes the platform management IPv6
address.
Configures the platform node name.
Deletes the platform node name.
Configures the fc-gs-3 defined platform type.
Deletes the configured type and reverts the
switch to its factory default of unknown type.
Exits the FCS registration attributes submode.
Exits the FCS registration submode.
Cisco MDS 9000 Family CLI Configuration Guide
FCS Name Specification
55-3