Vrrp Tracking Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Table 156 VRRP Interface Configuration Menu options
Command
cur

VRRP Tracking configuration

Command: /cfg/l3/vrrp/track
[VRRP Tracking Menu]
This menu is used for setting weights for the various criteria used to modify priority levels during the
master router election process. Each time one of the tracking criteria is met, the priority level for the virtual
router is increased by an amount defined through this menu.
NOTE: These priority tracking options only define increment values. These options do not affect the
VRRP master router election process until options under the VRRP Virtual Router Priority Tracking
Menu are enabled.
The following table describes the VRRP Tracking Configuration Menu options.
VRRP Tracking Configuration Menu options
Table 157
Command
vrs <0-254>
ifs <0-254>
ports <0-254>
cur
Description
Displays the current configuration for this IP interface's authentication parameters.
vrs - Set priority increment for virtual router tracking
ifs - Set priority increment for IP interface tracking
ports - Set priority increment for VLAN switch port tracking
cur - Display current VRRP Priority Tracking configuration
Description
Defines the priority increment value (0 through 254) for virtual routers in master mode
detected on this switch. The default value is 2.
Defines the priority increment value (0 through 254) for active IP interfaces detected on this
switch. The default value is 2.
Defines the priority increment value (0 through 254) for active ports on the virtual router's
VLAN. The default value is 2.
Displays the current configuration of priority tracking increment values.
Configuration Menu
186