Ospf Virtual Link Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

Hewlett-packard switch user manual
Table of Contents

Advertisement

OSPF Virtual Link configuration

Command: /cfg/l3/ospf/virt <1-3>
[OSPF Virtual Link 1
The following table describes the OSPF Virtual Link Configuration Menu options.
Table 146
OSPF Virtual Link Configuration Menu options
Command
aindex <0-2>
hello <1-65535>
dead <1-65535>
trans <1-3600>
retra <1-3600>
nbr <IP address>
key <password>
mdkey <1-255>|none
enable
disable
delete
cur
Menu]
aindex
- Set area index
hello
- Set hello interval in seconds
dead
- Set dead interval in seconds
trans
- Set transit delay in seconds
retra
- Set retransmit interval in seconds
nbr
- Set router ID of virtual neighbor
key
- Set authentication key
mdkey
- Set MD5 key ID
enable
- Enable interface
disable
- Disable interface
delete
- Delete interface
cur
- Display current OSPF interface configuration
Description
Configures the OSPF area index.
Configures the authentication parameters of a hello packet, which is set to be in
an interval of seconds.
Configures the health parameters of a hello packet, which is set to be in an
interval of seconds. Default is 40 seconds.
Configures the delay in transit in seconds. Default is one second.
Configures the retransmit interval in seconds. Default is five seconds.
Configures the router ID of the virtual neighbor. Default is 0.0.0.0.
Configures the password (up to eight characters) for each virtual link. Default is
none.
Sets MD5 key ID for each virtual link. Default is none.
Enables OSPF virtual link.
Disables OSPF virtual link.
Deletes OSPF virtual link.
Displays the current OSPF virtual link settings.
Configuration Menu 172

Advertisement

Table of Contents
loading

This manual is also suitable for:

10gb ethernet bl-c

Table of Contents