Ospf Virtual Link Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

OSPF Virtual Link Configuration

To display the following form, go to the OSPF Virtual Links Configuration form. Select a virtual link
number, or open the OSPF Virtual Links folder and click Add OSPF Virtual Link.
The following table describes the OSPF Virtual Link Configuration controls:
OSPF Virtual Link Configuration controls
Table 157
Control
Virtual Link Identifier (1-3)
Area Number (0-2)
Enabled?
Hello Interval (1-65535 sec)
Dead Interval (1-65535 sec)
Transmit Delay (1-3600 sec)
Retransmit Interval
(1-3600 sec)
Virtual Neighbor Router ID
Authentication Key
MD5 Key ID (0-255)
Descriptions
Assigns a numeric identifier to the virtual link.
Defines the area index used by the virtual link.
Enables or disables the OSPF virtual link.
Displays the authentication parameters of a hello packet, which is set to be in an
interval of seconds.
Displays the health parameters of a hello packet, which is set to be in an interval of
seconds. Default is 40 seconds.
Displays the delay in transit in seconds. Default is one second.
Displays the retransmit interval in seconds. Default is five seconds.
Displays the router ID of the virtual neighbor. Default is 0.0.0.0.
Displays the password (up to eight characters) for each virtual link. Default is none.
Sets MD5 key ID for each virtual link. Default is 0 (none).
Configuring the switch
230