To do...
2.
Enter Ethernet interface view
3.
Enable link-up port auto
power-down
This feature is only available on the HP 5800AF-48G Switch (JG225A).
When you configure the eee enable command on a link-up port, the port automatically goes down and
up.
Configuring a Layer 2 Ethernet interface
Layer 2 Ethernet interface configuration task list
Complete these tasks to configure an Ethernet interface operating in bridge mode:
Task
Configuring a port group
Enabling link-down port auto power-down
Setting speed options for auto negotiation on an Ethernet interface
Configuring traffic storm protection
Enabling single-port loopback detection on an Ethernet interface
Enabling multi-port loopback detection
Setting the MDI mode of an Ethernet interface
Enabling bridging on an Ethernet interface
Testing the cable connection of an Ethernet interface
Configuring the connection mode of an Ethernet interface
Configuring a port group
Some interfaces on your switch may use the same set of settings. To configure these interfaces in bulk
rather than one by one, you can assign them to a port group.
You create port groups manually. All settings made for a port group apply to all member ports of the
group. For example, you can configure a traffic suppression threshold (see
protection") for multiple interfaces in bulk by assigning these interfaces to a port group.
Even though the settings are made on the port group, they are saved on an interface basis rather than on
a port group basis. You can only view the settings in the view of each interface by use the display
current-configuration or display this command.
To configure a port group:
To do...
1.
Enter system view
Use the command...
interface interface-type interface-
number
eee enable
Use the command...
system-view
10
Remarks
—
Required
Disabled by default
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
"Configuring traffic storm
Remarks
—