Dell PowerConnect 5324 Command Line Interface Reference Manual page 79

bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove]
{ethernet interface-list | port-channel port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
• add—Adds ports to the group. If no option is specified, this is the default option.
• remove—Removes ports from the group.
• mac-multicast-address—MAC multicast address in the format of xx:xx:xx:xx:xx:xx.
• ip- multicast-address—IP multicast address.
• interface-list—Separate nonconsecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
• port-channel-number-list—Separate nonconsecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
• If the command is executed without add or remove, the command only registers the group in
the bridge database.
• Static multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 01:00:5e:02:02:03
The following example registers the MAC address and adds ports statically.
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 01:00:5e:02:02:03
add ethernet g1-9
Address Table Commands
79