Command Modes
Interface configuration (Ethernet)
User Guidelines
•
LLDP manages LAG ports individually. LLDP sends separate advertisements on each port in
a LAG. LLDP data received through LAG ports is stored individually per port.
•
LLDP operation on a port is not dependent on STP state of a port. I.e. LLDP frames are sent
and received on blocked ports. If a port is controlled by 802.1X, LLDP operates only if the
port is authorized.
Examples
The following example enables Link Layer Discovery Protocol (LLDP) on an interface (g5).
Console(config)# interface ethernet g5
Console(config-if)# lldp enable
lldp timer
To specify how often the software sends Link Layer Discovery Protocol (LLDP) updates, use the
lldp timer command in global configuration mode. To revert to the default setting, use the no
form of this command.
Syntax
lldp timer seconds
no lldp timer
•
seconds — Specifies in seconds how often the software sends LLDP update. (Range: 5 -
32768 seconds).
Default Configuration
Default - 30 seconds.
Command Modes
Global configuration
User Guidelines
•
There are no user guidelines for this command.
180
LLDP Commands