Address Table Commands; Bridge Address - Dell PowerConnect 5324 Command Line Interface Reference Manual

Address Table Commands

bridge address

The bridge address VLAN Interface Configuration mode command adds a static MAC-layer
station source address to the bridge table. To delete the MAC address, use the no form of the
bridge address command (using the no form of the command without specifying a MAC address
deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address mac-address {ethernet interface | port-channel port-channel-number}
[permanent | delete-on-reset | delete-on-timeout | secure]
no bridge address [mac-address]
• mac-address—A valid MAC address in the format of xx:xx:xx:xx:xx:xx.
• interface—A valid Ethernet port.
• port-channel-number—A valid port-channel number.
• permanent—The address can only be deleted by the no bridge address command.
• delete-on-reset—The address is deleted after reset.
• delete-on-timeout—The address is deleted after "age out" time has expired.
• secure—The address is deleted after the port changes mode to unlock learning (no port
security command). This parameter is only available when the port is in learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245
on port g8 to the bridge table.
Address Table Commands
77