Paper cannot be cut
The printed document became caught on a foreign
object by the Output Tray , which lifted the document.
The Cutter passed under the paper.
In the printer driver, No or Print Cut Guideline is
specied in Auto Cut .
In MAIN MENU , Eject or Manual is specied in
Cutting Mode .
Depression on the leading edge is left
Keeping a roll in the printer for a long time without
printing on it may leave a depression on the leading
edge.
Roller marks are left across the trailing edge of paper
A document was removed after printing from the
Front Paper Feed Slot without pressing the ▲ button.
The printer does not go on
The printer is unplugged.
The specied voltage is not supplied.
Cause
Cause
Cause
Cause
Corrective Action
Remove the foreign object by the Output Tray to
enable the printer to eject the printed document,
keeping it level.
Specify Yes in Auto Cut in the printer driver.
Specify Automatic in Cutting Mode in MAIN MENU .
Corrective Action
When printing quality is most important, we
recommend setting TrimEdge Reload to On or
Automatic so that the paper edge is automatically
cut before printing.
Corrective Action
Following the instructions, press the ▲ button,
remove the paper, and then press the ▼ button.
Wipe away any soiling on the rollers. (→P.670)
(→P.673)
Corrective Action
Plug the power cord into the outlet, and then turn on
the printer.
Check the voltage of the outlet and breaker.
For information on the specied voltage, see
"Specications". (→P.72)
Other problems
Troubleshooting 725