Canon imagePROGRAF iPF5100 User Manual page 590

Network Setting
8.
Press ◄ or ► to select the number, and then press the OK button.
Note
•
Pressing the ◄ button decreases the number by 1. The minimum value is "0," after which "255" is
displayed.
•
Pressing the ► button increases the number by 1. The maximum value is "255," after which "0" is
displayed.
•
Hold down ◄ or ► to increase or decrease the value continuously.
9.
Repeat steps 6-8 to enter the IP address assigned to the printer.
10.
Press the Online button to bring the printer online.
If any of the settings are changed, a message for conrmation is displayed. In this case, press
the OK button.
Note
•
If an error message is displayed, check the settings and correct any invalid values.
•
To cancel the setup process, hold down the Stop/Eject button for a second or more.
Important
•
Be sure to complete step 10. This will activate the values you have entered.
•
You can also specify the subnet mask and default gateway on the Control Panel.
576 Network Setting
IP Address
=xxx.0.0.0
IP Address
=xxx.xxx.xxx.xxx