Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Straight; Paper Cannot Be Cut - Canon imagePROGRAF iPF605 User Manual

Problems Regarding Paper

Roll Paper Cannot be Inserted into the Paper Feed Slot

The roll paper is warped.
The roll was pulled out by force when it had been
advanced before printing, and this action closed the
Paper Feed Slot.

Cannot Load Sheets

The paper source selection is incorrect.

Paper is not cut straight

The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before
it is cut.

Paper cannot be cut

The printed document became caught on a foreign
object by the Output Tray, which lifted the document.
The Cutter passed under the paper.
In the printer driver, No or Print Cut Guideline is
specied in Auto Cut.
In MAIN MENU, Eject or Manual is specied in
Cutting Mode.

Depression on the leading edge is left

Keeping a roll in the printer for a long time without
printing on it may leave a depression on the leading
edge.
Roller marks are left across the trailing edge of paper
A document was removed after printing from
the Front Paper Feed Slot without pressing the
Load/Eject button.
514 Troubleshooting
Cause
Cause
Cause
Cause
Cause
Cause
Corrective Action
Straighten out curls and reload the roll.
Follow these steps to remove the roll and open the
feed slot.
1.
Press the Load/Eject button.
A conrmation message is displayed regarding
removal of the roll.
2.
Press the OK button.
Corrective Action
Press the Feeder Selection button to activate the
Cut Sheet lamp.
Corrective Action
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Corrective Action
Remove the foreign object by the Output Tray to
enable the printer to eject the printed document,
keeping it level.
Specify Yes in Auto Cut in the printer driver.
Specify Automatic in Cutting Mode in MAIN MENU.
Corrective Action
When printing quality is most important, we
recommend setting TrimEdge Reload to On or
Automatic so that the paper edge is automatically
cut before printing.
Corrective Action
Following the instructions, press the Load/Eject
button, remove the paper, and then press the OK
button.
Wipe away any soiling on the rollers.
(→P.495)
(→P.498)