Cutting Error - Canon imagePROGRAF iPF5100 User Manual

Messages regarding paper

Cutting Error

There are sheets left on the Output Tray .
There is a foreign object by the Output Tray ,
obstructing the Cutter Unit .
You are not using the printer under the recommended
environmental conditions for the paper.
You are using paper that is not compatible with
automatic cutting.
The Cutter Unit stops in the middle of cutting.
In other cases, the Cutter Unit may be damaged.
Roll P Unit / Please Check
The printer has received a print job that species
rolls, but the Roll Feed Unit is not installed.
748 Error Message
Cause
Cause
Corrective Action
Remove the paper.
Remove the foreign object.
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see "Types of Paper". (→P.107)
Cut the roll manually.
(→P.130)
Move the Cutter Unit to the left, and then remove the
roll paper. If the roll cannot be cut using the Cutter
Unit , cut the roll manually.
(→P.130)
Contact your Canon dealer for assistance.
Corrective Action
Change the paper source in the printer driver to a
source other than roll, and then try printing again.
Install the Roll Feed Unit and resend the print job.