Cut Sheets Cannot Be Pulled Out From The Front Paper Feed Slot; Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly - Canon imagePROGRAF iPF6400S User Manual

Cut sheets cannot be pulled out from the front paper feed slot

Cut sheets cannot be pulled out from the front paper feed slot Cut sheets cannot be pulled out from the front paper feed slot
Cause
You have loaded
paper other than
POP board.

Roll paper cannot be inserted into the paper feed slot

Roll paper cannot be inserted into the paper feed slot
The roll paper is warped.
Paper is jammed by the paper feed slot.
After a roll was advanced, the paper was manually pulled out by force, closing the
Paper Feed Slot.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before it is
cut.
You are using paper that cannot be cut with the Cut-
ter Unit.
Cut Speed is not configured correctly in the Control
Panel menu.
During cutting, printed documents fall out at an an-
gle.

Paper is not cut

Paper is not cut
The printed document became caught on a foreign object by the
Output Tray, which lifted the document. The Cutter passed under
the paper.
946
In the printer driver, No or Print Cut Guideline is specified in Au-
tomatic Cutting.
Push the cut sheet from the front side of the printer towards the back side. Once the edge of the cut sheet protrudes from
the back side of the printer, pull it out from the back side.
Cause
Press the Load button and select the paper source.
Cause
Cause
Corrective Action
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet, Fed Manually.")
Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")
Corrective Action
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a cut-
ting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
P.628
➔
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after printing,
as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Remove the foreign object by the Output Tray to enable the printer to
eject the printed document, keeping it level.
Specify Yes in Automatic Cutting in the printer driver.
Corrective Action
➔
Corrective Action
P.520
➔
P.520
➔
Corrective Action
iPF6400S
P.938
P.941
➔
P.514
➔
User's Guide