Chapter 2: Setting Up Network Servers; Fiery On A Tcp/Ip Network With; Windows Nt 4.0/2000/Xp/Server 2003/Server 2003 - Oki ES3640eMFP Configuration Manual

2
2-26 Fiery on a TCP/IP network with Windows NT 4.0/2000/XP/Serv-
Chapter 2:
Setting up
Network
Servers
This chapter describes environments that typically include one or
more network servers—Novell NetWare servers and
Windows NT 4.0/2000/Server 2003 servers—that share printing
to the Fiery. It describes setting up servers that use IPX/SPX or
TCP/IP protocols for communicating with the Fiery. In addition, it
includes guidelines for setting up direct communication from
Windows NT 4.0/2000/XP/Server 2003 workstations or UNIX
workstations, where a network server is optional. This chapter
also outlines the requirements for users to print to the Fiery and
run Fiery utilities and Fiery WebTools.
The Fiery can accept jobs concurrently from NetWare,
Windows NT 4.0/2000/Server 2003, and AppleShare servers, as
well as jobs sent directly from Windows or UNIX workstations.
Because AppleShare servers require no special configuration, they
are not discussed in this chapter, except for use in a
Windows NT 4.0/2000/XP/Server 2003 environment (see
on a TCP/IP network with Windows NT 4.0/2000/XP/Server 2003/
Server 2003" in the following section).
If your network is based on Windows NT 4.0/2000/Server 2003,
proceed to the following section. For information on UNIX
workstations, proceed to

Fiery on a TCP/IP network with

Windows NT 4.0/2000/XP/Server 2003/Server
2003
When a Windows NT 4.0/2000/XP/Server 2003 computer is
configured to connect to the Fiery using TCP/IP, it can print
directly to the Fiery. If the computer shares the printer over the
network, it is acting as a print server to Windows clients. Client
computers print to the Fiery by printing to the Windows NT 4.0/
2000/Server 2003 print server. You can then monitor and control
printing at the Windows NT 4.0/2000/Server 2003 server
computer.
ES3640e MFP EFI Configuration Guide - 26
page 2-44.
"Fiery