Oki ES3640eMFP Configuration Manual page 25

1
1-25 Connecting network cable to the Fiery
To connect to the Ethernet port
• Connect the network cable to the RJ-45 connector on the back of
the printer.
You must use a Category 5 unshielded twisted pair cable network
cable for 100BaseT.
Parallel cable connection
The Fiery can accept print jobs from a Windows computer through
its high-speed parallel port. This connection is advantageous for
portable computers and for workstations on dedicated networks
using protocols other than AppleTalk, TCP/IP, or IPX.
The parallel port connection can be active at the same time as the
network ports.
Note:
Command WorkStation or other Fiery utilities.
To use parallel or USB cable
1. With the ES3640e MFP and the Windows computer turned off,
attach the parallel or USB cable to the parallel or USB port of the
printer.
For the location of the parallel and USB ports, see the illustration
on page
2. Connect the other end of the cable to the parallel or USB port on
the Windows computer.
3. Turn on the computer and the ES3640e MFP.
4. Proceed to Setup.
ES3640e MFP EFI Configuration Guide - 25
The parallel port cannot be used to connect the Fiery with
1-24.