Setting Up Fiery Webtools; Setting The Weblink Destination - Oki ES3640eMFP Configuration Manual

6

6-145 Setting up Fiery WebTools

To access WebTools
1. Start your Internet browser.
2. Enter the IP address or DNS name of the Fiery.
3. Press Enter.
The Fiery home page appears.
4. Click the name of a particular WebTool.
5. Click Configure to enable specific WebTools for users.
Setting up Fiery WebTools
In order for network users to access and use Fiery WebTools, you
must set certain Fiery options in Network Setup and Printer Setup.
You also must prepare each user's workstation to communicate
with the Fiery over the Internet or intranet.
For more information on Network Setup, see
To set up Fiery WebTools on the Fiery
1. Set Enable Ethernet to Yes in Network Setup > Port
Setup > Ethernet Port Setup.
2. Set Enable TCP/IP for Ethernet to Yes in Network Setup > TCP/IP
Ethernet Setup.
3. Set Enable Web Services to Yes in Network Setup > Network
Service Setup > Web Services Setup.
4. Exit Network Setup. Choose OK to Save Changes.

Setting the WebLink destination

You can change the pre-set WebLink destination; this function
requires the Administrator password, if one has been set.
ES3640e MFP EFI Configuration Guide - 145
Chapter 2.