Oki ES3640eMFP Configuration Manual page 50

3
3-50 Preparing for Fiery Setup
configure Printer Setup. All published connections are constantly
checked for the presence of jobs. The Print queue and Direct
connection give remote users more direct access to the Fiery than
the Hold queue. Therefore, do not publish the Print queue and the
Direct connection in environments where maximum control is
desired.
In addition, you can enable the Printed queue, which is a storage
area for the most recent jobs from the Print queue. The Printed
queue makes it convenient to reprint those jobs. In Setup, you
can enable the Printed queue and specify the maximum number of
jobs retained in the queue (see page 4-66). Reprinting jobs in the
Printed queue requires the job management tools.
To use the Fiery utilities and Fiery WebTools, you must
Note:
enable at least one of the print connections.
Hold queue
Jobs sent to the Hold queue are spooled to the Fiery hard disk for
printing at a later time or for reprinting. Because the Hold queue
is a storage place, jobs sent to it cannot proceed through the
printing process until the operator intervenes using the job
management tools (see the Job Management Guide).
Print queue
This is the standard Fiery queue. Jobs sent to the Print queue are
processed and printed in the order they are received. Jobs
prioritized by an operator with the job management tools and jobs
sent via the Direct connection can take priority over jobs sent to
the Print queue.
Direct connection
The Direct connection transmits jobs directly to the Fiery, but only
when the Fiery is Idle. If the Fiery is busy, the job remains at the
user workstation until the Fiery is ready. The job is then processed
as soon as the previous job is finished and before the next queued
job is processed.
ES3640e MFP EFI Configuration Guide - 50