Oki ES3640eMFP Configuration Manual page 161

A
A-161 Troubleshooting the Fiery
After this Setup
screen
Enable AppleTalk
(Network
Setup > Protocol
Setup > AppleTalk
Setup)
Protocol Setup or
Service Setup (Network
Setup)
Frame Type selection
(Network
Setup >Protocol
Setup >IPX/SPX Setup)
Enable NDS
(Network
Setup > Service
Setup > PServer
Setup > NDS Setup)
Network Setup messages
This message
No AppleTalk zone
found.
You must first enable
a network port.
Invalid frame size.
Warning! IPX network
number is zero.
No NDS trees found.
ES3640e MFP EFI Configuration Guide - 161
Means
The Ethernet network cable is not attached
to the connector on the ES3640e MFP, or the
network cable is not plugged into the hub or
network. If your AppleTalk network has
zones, and you want to specify a zone for the
Fiery, you must connect the network cable to
the Fiery before performing AppleTalk Setup.
This could also mean that the AppleTalk
network does not have zones. Zones are not
required for printing to the Fiery. Press Enter
to continue.
Enable at least one network port (Ethernet)
in Port Setup before beginning Protocol
Setup or Service Setup.
The network hub is not connected to a Novell
machine when the Fiery tries to bind.
No other IPX machine can be found on the
network, or the network hub is not
connected to the network when the Fiery
tries to bind. When this occurs, the network
number defaults to zero.
No NDS trees were found on the Novell
network. Check to see that the frame types
on the Fiery are properly configured.