Quick Path To Installation - Oki ES3640eMFP Configuration Manual

1

1-17 Quick path to installation

Quick path to installation
The diagrams on the following pages show typical systems you
can use to print and run Fiery software from remote workstations.
Find the page with your preferred platform and network type, and
then look up the setup procedures referenced in the "Key to
setup" in the upper-left corner of each diagram.
The diagrams describe devices that use the supported networking
protocols. They are logical diagrams and are not intended to
describe the physical arrangement (topology) of devices on the
network. A variety of physical arrangements is possible with each
logical arrangement. For example, twisted pair Ethernet networks
commonly use a star configuration around a hub, rather than a
bus arrangement. The design of physical networks is beyond the
scope of this manual.
If your network uses more than one protocol or more than one
type of workstation, combine the setups listed for each
component of your system. Multiple protocols (shown in the
diagrams as parallel lines) can run on the same cable. A solid
connection from the Fiery with an arrow indicates that other
supported network types can be operational at the same time.
The protocols used in these diagrams are indicated as follows:
Parallel
IPX (Novell)
AppleTalk
Other
TCP/IP
(lpd, nbt, or
http)
ES3640e MFP EFI Configuration Guide - 17