Oki ES3640eMFP Configuration Manual page 90

4
4-90 Performing Setup from the Printing Unit Control Panel
Network Setup
Service Setup
Windows Setup
Windows Setup options
Enable Windows Printing
Yes/No [Yes]
Enabling Windows Printing enables Server Message Block (SMB), the
file and printer sharing protocol built into Windows. Enabling SMB
allows the Fiery to be listed on the network so that Windows clients
can print to a particular print connection (Hold, Print, or Direct) on the
Fiery without any other networking software. For information on
setting up a Windows computer for Windows printing, see the User
Software Installation Guide. Windows printing runs via TCP/IP, so you
must configure TCP/IP on the Fiery and on all computers that
use Windows printing.
Use Automatic Configuration
Yes/No [No]
This option appears if you chose DHCP or BOOTP as the protocol
for automatically obtaining the IP address of the Fiery.
Choose Yes and the Fiery uses a WINS name server and automat-
ically obtains its IP address. Make your choice and proceed to the
Server Name option.
Choose No to proceed to the Use WINS Name Server option,
where you specify whether to use a WINS name server, and then
to the WINS IP Address option, where you specify its IP address.
Use WINS Name Server
Yes/No [No]
Broadcasts from SMB devices cannot pass across a router without
a WINS name server. Setting up the WINS name server is outside
the scope of this manual. To find out if a name server is available,
contact your network administrator.
ES3640e MFP EFI Configuration Guide - 90