Ensuring The Printer Connection - Oki ES3640eMFP Configuration Manual

3
3-58 Preparing for Fiery Setup
Note:
Windows NT 4.0/2000/Server 2003 domain name. This is
especially important for Windows printing, also known as
SMB printing.
Note:
Active Directory Service. When you use the Fiery in a Windows
2000/Server 2003 server environment, assign the Fiery to a
Domain or Workgroup.

Ensuring the printer connection

Complete the following steps before you configure the Fiery and
the workstations that will print to the Fiery. A service technician
will have performed some initial installation.
To prepare for Fiery configuration
1. Print a printer Test Page to verify the printer is functioning
normally.
2. With the the printer turned off, connect the network cable to the
the printer, as described in
The network should already be installed and operational.
3. Turn on the printer.
Proceed to Fiery Setup, described in Chapter 4.
ES3640e MFP EFI Configuration Guide - 58
You must configure the Fiery with the correct
The Fiery does not support the Windows 2000/Server 2003
Chapter 1.