Oki ES3640eMFP Configuration Manual page 72

4
4-72 Performing Setup from the Printing Unit Control Panel
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP
Configuration. Select the protocol over which the Fiery should
search for its IP address. Both DHCP and BOOTP allow the Fiery to
obtain the Ethernet IP address and Subnet Mask automatically.
Depending on your network, the Fiery might be assigned a differ-
ent address after you restart the Fiery. With the DHCP setting, the
Fiery can be assigned a different address even if it is not
restarted. Make sure the network is already configured properly
for the protocol you select.
Auto Gateway Address
Yes/No [Yes]
Use this option to assign the gateway address automatically for
printing with TCP/IP.
IP Address
[127.0.0.1]
Enter the Fiery IP address for Ethernet. This IP address, unlike an
IP address set automatically, remains the same if you restart the
Fiery. You must change the default to a valid address for your net-
work. For information about setting up printing with TCP/IP, see
Chapter 2.
Subnet Mask
This option lets you modify the subnet mask for printing with
TCP/IP over Ethernet. To set the subnet mask, enter one of the
following values:
• 255.0.0.0 if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128
through 191
ES3640e MFP EFI Configuration Guide - 72