Table of Contents
Advertisement
6. Following the instructions packaged with the applicator, apply thermal grease to the processor.
7. Insert the heat sink into the air baffle and place it on top of the processor (Figure 17, A).
8. Install both heat sink clips as follows:
a. Place the heat sink clip on the center tab of the retention module and slide the clip to the
right to engage the center tab.
b. Snap one end of the clip down over the corresponding tab on the retention module.
c. Snap the remaining end of the clip down over the corresponding tab.
A
B
Heat sink
C
Socket and processor
D
Figure 17. Installing the Heat Sink
Retention module
Heat sink retention clips
44
Advertisement
Table of Contents
