Removing The Rear Access Cover; Installing The Rear Access Cover; Figure 3. Removing The Rear Access Cover - Intel SRSH4 - Server Platform - 0 MB RAM Service Manual

Removing the Rear Access Cover

The rear access cover provides access to the hot-swap fans and to the electronics bay that contains
PCI add-in cards and the server board set. To remove the cover:
1. Release the captive screws located on the rear edge of the cover (Figure 3).
2. While lightly pressing down on the cover, slide it toward the rear of the chassis.
3. Lift the cover up and off of the chassis.

Installing the Rear Access Cover

NOTE
Before installing the rear access cover, check that you have not left tools or
loose parts inside the system.
To install the rear access cover:
1. Position the cover on the chassis so that the cover tabs align with the chassis slots.
2. While lightly pressing down on the cover, slide it toward the front of the chassis until the cover
tabs fully engage the chassis slots.
3. Attach the cover to the chassis with the captive screws located on the rear edge of the cover.
Installing and Removing Components

Figure 3. Removing the Rear Access Cover

29